Publicidad
Idiomas disponibles
Idiomas disponibles
EN
30
Wall drilling and bracket attachment
•
Please read these instructions carefully.
•
Unpack the hood and check all functions. Ensure that
•
the voltage (V) and frequency (Hz) stated on the nameplate correspond to the
voltage and frequency at the installation location.
•
Make sure there are no electrical cables, pipes, etc. running behind the
surface to be drilled.
•
The stainless steel and glass surfaces of the hood can easily be damaged
•
during installation if tools brush against them or strike them. Be sure to
protect surfaces during installation.
•
Protect the surface of the hob with cardboard or similar
•
to prevent it from being damaged when installing the wall extractor hood.
•
The manufacturer is not liable for failure to comply with all applicable safety
regulations for the correct and proper operation of electrical parts.
Choice of venting mode
Extraction-air mode
Position of the vent switch
Recirculation mode
Exhaust air mode: This
position of the switch
ensures that air is
exhausted outside.
Recirculation mode: This
position of the switch
ensures that the air is
circulated inwards.
Publicidad
