Installing the carbon filter
•
Remove the grease filter
•
The charcoal filter is located at end of the motor. Turn the carbon filter until it
is unscrewed.
•
The filter cotton is located on the metal mesh and fixed by one iron wire.
•
Replace with a new carbon filter, carry out the installation procedure in
reverse.
•
Replace with a new filter cotton, carry out the installation procedure in
reverse.
•
Warning: The carbon filter(or filter cotton) cannot be washed or recycled. It
should be replaced after approximately 2-3 months of use.
•
Remark: Carbon filter (or filter cotton) is not supplied with your appliance.
Carbon Filt er
TROUBLESHOOTING
Fault
The light turns on but
the motor does not run.
O
p
n e
Close
Possible Cause
The rotor blades are
blocked.
The capacitor is
defective.
The motor is defective.
The motor's internal
wiring has been cut/
disconnected. An
unpleasant odour may
arise.
iron wire
filter option
Solution
Replace capacitor.
Replace motor.
Replace motor.
EN
37