RHOSS Compact-Y SM TCAEY 122 P0 Instrucciones De Uso página 30

II.4.2 LIFTING AND HANDLING
DANGER!
Movement of the unit should be performed with
care, in order to avoid damage to the external
structure and to the internal mechanical and
electrical components. Also make sure that there
are no obstacles or people blocking the route, to
avoid the danger of collision or crushing. Make sure
that there is no possibility of the lifting-gear
overturning.
The unit is supplied on a wooden support structure. This structure
serves to facilitate unit transport using a forklift or a hand truck. Use this
method to transport the unit to the installation position.
On arrival at the final installation site, remove the wooden substructure
(unscrew the 4 screws). Pass the straps through the slots in the base of
the unit, having first checked their suitability (as regards their strength
and state of wear and tear). Take the strain on the slings, checking that
they remain properly attached to the lifting-hook; lift the unit a few
centimetres, then, only after checking the stability of the load, slide the
pallet out, taking care not to trap any parts of the body, in order to
eliminate any possible risk of crushing or any other injury if the load
drops or shifts suddenly. Carefully carry the unit to the installation site.
Lower the unit carefully and fix it into place.
II.4.2.1 Handling precautions
DANGER!
The centre of gravity is off-centre and could cause
sudden and hazardous movements. Movement of
the unit should be performed with care, in order to
avoid damage to the external structure and to the
internal mechanical and electrical components.
Also make sure that there are no obstacles or
people blocking the route, to avoid the danger of
collision, crushing or the lifting-gear overturning.
I ON
I ON
Model
TCAEY-THAEY 122 P1
TCAEY-THAEY 122 ASP1
TCAEY-THAEY 127 P1
TCAEY-THAEY 127 ASP1
TCAEY-THAEY 130 P1
TCAEY-THAEY 130 ASP1
30
Compact-Y SM
X Y
X Y
X
mm 540
mm 700
mm 630
mm 800
mm 630
mm 800
Y
250
250
300
300
300
300