Publicidad
Idiomas disponibles
Idiomas disponibles
J ..–-–-–.
. .
. ... .
..-.l..–
1
2
3
CLOCK
Press CLOCK/TIMER
once, then press
II
SET
within 4 seconds.
The hour flashes.
When using the remote control
Press CLOCK,
then press II
SET
within 4 seconds.
Press <
DOWN or FF
UP to designate
the
hour, and press 11 SET.
The hour stops flashing and the minute starts flashing.
Press +
DOWN or *
UP to designate
the
minute and press II SET.
The minute stops flashing on the display and
the clock starts
from 00 second.
-
To display the current time
Press
CLOCIQTIMER
once. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press
CLOCWTIMER
once, then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately
24 hours,
all settings stored in memory after purchase need to be reset.
*MULTI JOG is also available instead of U
and W.
ENTER is also available instead of II SET.
The unit can be turned off automatically
at a specified time.
Use the remote control.
7
Press SLEEP.
2 Within 4 seconds,
press -
or ~
to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press
SLEEP
once.
The remaining
time is displayed
for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEP oFF appears on the display.
'MULTI JOG k also available instead of U
and W.
21
ENGL/S/+
Publicidad
