Publicidad
Idiomas disponibles
Idiomas disponibles
6
1,2, 3,4
2,3,4
----
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
Press CLOCIVTIMER
twice to display
0,
then
press 11 SET within 4 seconds,
@
is displayed, and the hour flashes.
When using the remote control
Press TIMER,
then press [1 SET within 4 seconds.
m
If you press 11 SET after 4 seconds, another operation may
start.
Designate
the
hour
of the
timer-on
time
by
pressing
+-4
DOWN or -
UP, then press 11
SET. Repeat to designate the minute of the timer-
After you designate the timer-on time, one of the source names
flashes on the display.
Press ~
DOWN or P=b UP to select a source,
then press II SET.
@
If TUNER
is selected,
the band cannot be selected
in this
step,
4 Select the duration for the timer-activated
period
E
with -44
DOWN or ~
UP, then press 1I SET.
,;*,
G
The duration for the timer-activated
period can be set between
5 and 240 minutes in 5-minute steps.
5 Prepare the source.
To listen to a CD,
load the disc to be played first on tray 1.
To listen to a tape, insert the tape into deck 1 or 2.
To
listen to the radio,
tune in to a station.
6 Press POWER to turn the unit off after adjusting
the volume and tone.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached,
the unit turns on and
begins play with the selected source.
a The volume level is automatically
set to 20 when the power
is turned off with the volume level set to 21 or more.
To check the specified time and source
Press
TIMER
once on the remote control. The timer-on time, the
timer-activated
period
and the selected
source
name
are
displayed for 4 seconds.
To cancel timer standby mode temporarily
Press
TIMER
on the remote control repeatedly until@ or @REC
disappears
on the display.
To restore the timer standby mode, press TIMER
again once or
twice to display @ or @REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare
the
source, and adjust the volume and tone.
* Timer playback and timer recording will not begin unless the
power is turned off.
* Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER
and VIDEO/AUX
(with
an external timer) sources only.
Press TIMER on the remote control repeatedly
until ~
REC appears on the display, then press 11 SET within 4
seconds.
Carry out the steps of "SETTING
THE TIMER" from step 2 and
insert the tape to be recorded into deck 2 after step 5.
'MULTI JOG is also available instead of U
and >.
ENTER is also available instead of II SET.
ENGLISH
22
Publicidad
