Removing The Drill Chuck - BDS Maschinen MAB 855 Instrucciones De Manejo

MK tool/industrial tool holder
Using the drill chuck
MAB 855
Fitting the tool/industrial tool holder
Before fitting, clean the tool shank, adapter or industrial tool
‹
holder and the spindle taper (3) of the machine.
Insert the tool into the spindle taper (3) of the machine from
‹
below.
NOTE
► When using tools/adapters with MK2 taper, use MK3:2
adapter sleeve.
Removing the tool
Turn the tool until the ejector pin (H) slips into the opening for
‹
the ejector pin (4).
Lever out the tool with the ejector pin (H) or loosen the tool
‹
by tapping against the ejector pin.
Inserting the drill chuck
Insert the drill chuck onto the tapered mandrel and insert
‹
the combination into the spindle taper (3) of the machine. If
necessary, use an adapter sleeve.
Open the drill chuck and insert the tool into the drill chuck.
‹
Close the drill chuck by hand and then tighten the drill chuck
‹
with the chuck key.

Removing the drill chuck

Loosen the drill chuck with the chuck key and remove the
‹
tool.
WARNING
Risk of injury!
► Only tighten the drill chuck with the chuck key provided.
► Always remove the chuck key from the drill chuck after tight-
ening or loosening.
Operation
47