Tenda K4P-4CR Guia De Instalacion página 7

II Install the camera
Tips
Please make sure the wall or the ceiling is strong enough to withstand three times the weight of the camera.
−
−
You may need to prepare a hammer drill, a drill bit, a rubber hammer, a screwdriver, and a ladder for the installation.
Remove the base
Rotate the body of the camera, align the housing slot with any base notch, and then use a screwdriver to
pry the housing at the slot to remove the base.
Fix the camera
The camera supports ceiling and wall mounting. The ceiling mounting is taken as an example here.
Mounting template
Adjust the monitoring direction
Mounting template
Base
Screw
Base
Screw
Base notch
Housing slot
Anchor
A Run the cable through the side
B Run the cable through the bottom
- 4 -