Tenda K4P-4CR Guia De Instalacion página 8

III Connect the device
The K4P-4CR kit is taken as an example here.
Internet
Router
WAN
Computer
IV Basic configuration
Local management
Startup
Note
Use the included power adapter to power on the NVR. The NVR may fail to work normally or even be damaged due to abnormal power supply.
Connect the included power adapter to the power port of the NVR, and plug the power adapter into the
power socket to start up the NVR.
Shutdown
Note
Do not directly cut off the power supply of the NVR to force a shutdown; otherwise, the HDD may be damaged, videos may be lost, or even the
NVR may be damaged.
After connecting the mouse and monitor to the NVR, perform the following settings on the NVR's web UI
(exit the Full Screen interface): Click
When The Device is Shut Down. Please Cut Off the Power appears on the screen, unplug the power
adapter of the NVR.
Quick setup
After connecting the mouse and monitor to the NVR, you can perform quick setup.
Select the language displayed on the GUI and the time zone in which the NVR locates, and then click
OK.
Ethernet cable
LAN
LAN
PoE Camera
in the upper right corner, click Shutdown
Initial Setup
Engilsh
Language
Time Zone (UTC+8:00) Beijing, Chongqing, H
2022 - 01 - 14
Date
Time 11 : 26 ：51
LAN
1 3
2 4
POWER POWER PoE PORTS LAN
PoE
PoE Camera
PoE Camera
OK
- 5 -
IN
OUT
AUDIO HDMI VGA USB1 USB2
HDMI cable
or VGA cable
PoE Camera
, and then click OK.
Shutdown
PoE NVR
Monitor