Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
02
2
Bumper error
03
3
Free-fall sensor
error
02
4
Low battery or
charging error
Beeps while the indicator light is steady red:
Beeps
Error
01
1
Driving wheel error
02
2
Robot's side brushes
error
03
3
Fan error
02
4
Main brush error
Other possible scenarios:
Problem
The robot vacuum
cleaner does not
activate.
The device suddenly
stops working.
The programming
function does not work
Suction power level is
very low
48
Check the bumper and remove any object that may
be blocking it.
Check if the bumper is dirty and clean the sensor.
The robot has run out of battery and you need to
manually place it on the charging base.
Solution
Check if the driving wheel is blocked. Unblock and
clean it.
Check if the side brushes are blocked and clean
them.
Clean the dust or objects that may be blocking the
air inlet channel.
Check if the main brush is tangled or blocked and
clean it.
Solution
Make sure the power switch is in the on position (I).
Make sure the battery is fully charged.
If the problem continues, turn the switch off and restart it.
Check if the robot is trapped or stuck with any obstacle.
Check the battery level.
If the problem continues, turn the switch off, wait for 2 seconds
and restart it.
Make sure the power switch is in the on position (I).
Check if the robot battery is too low to turn on.
Check if there are obstructions blocking the air inlet.
Empty the tank.
Clean the filters with a vacuum cleaner or a cleaning brush.
Check if the filters are wet.
Dry the filters in a natural way before using them. Make sure
they are completely dry, if there are any moisture remains they
could reach the motor and damage the robot.
Publicidad
