cecotec HYDROBOOST 3200 TOTALCLEAN Manual De Instrucciones página 72

ENGLISH
- 4 UltraJet nozzle tips (0-40º)
- 3DTurboFlip nozzle
- 360Brush (special for wheel rims)
- EasyClean brush (special for gaskets)
- Soap bottle
- Trigger gun
- Lance
- Anti-impurities filter
- Nozzle-cleaning needle
- 2-Spin brush
- Instruction manual
3. PRODUCT ASSEMBLY
- Fit the high-pressure hose (5) to the pressurised water outlet of the pressure washer (6).
- Attach the trigger gun (7) to the high-pressure hose (5). Before turning on the machine,
make sure the high-pressure hose (5) is completely unwound. The hose (5) should not
become entangled while in use.
- Install the spray nozzle or the item to be used.
- Check the anti-impurities filter (10) is not blocked.
- Connect the pressure washer to the power supply (8) and water supply (3).
Note
It is very important to let air out of the trigger gun before using the pressure washer. Press
the trigger to let all the trapped air out of the unit and the high-pressure hose. Hold down the
trigger until a continuous water jet comes out of the nozzle. This process may take 2 minutes.
4. OPERATION
Note
Beware of the recoil caused by the force of the water when activating the pressure washer.
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle bodywork
or rims, lacquered surfaces, wood, paintwork, etc.
Product performance
Note
The motor of this pressure washer does not run continuously. It only runs when pressing the
trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
72
HYDROBOOST 3200 TOTALCLEAN