Publicidad
Idiomas disponibles
Idiomas disponibles
Note:t his is a wand accessory and does not fit the gun. To fit it,push it in and then turn to lock.
Note
Before using the 2-spin brush, you must check it will not damage the surface to be cleaned by
testing it on an inconspicuous place.
Cleaning process
The following cleaning procedure will help you organise and ensure you get the best results.
Remember to follow the previous advice.
Preparing the surface
-
Clear the area of furniture and check that windows and doors are securely closed.
-
Also make sure that plants and trees near the area to be cleaned are protected with a cloth.
Initial high-pressure rinse
Spray the area to be cleaned with water to clean any dirt that may have accumulated on the
surface.
Using soap
Water and soap must be used in a 1:19 ratio: 5.4% soap, 94.6% water.
Warning
Use only soaps designed for pressure washers.
-
Test the soap in an inconspicuous place before using the product.
-
Loosen the cap of the soap bottle and fill it with water and soap.
-
Replace the cover.
-
Disassemble the lance from the trigger gun.
-
Attach the soap bottle to the trigger gun. Fig. 7
-
Apply soap in such a way to cover the whole surface to be cleaned. Apply it from bottom to
top to prevent soap from dripping down and staining the surface.
-
Leave the soap to act on the surface for several minutes. However, in particularly soiled
areas, use a brush to gently scrub. Do not allow soap to dry on the surface.
-
Remove the soap bottle from the gun and replace it with the wand and nozzle or accessory
to be used.
-
Rinse the soap from the surface.
Note: rinse the soap bottle with clean water after every use.
ENGLISH
HYDROBOOST 3200 TOTALCLEAN
75
Publicidad
