cecotec CONGA ROCKSTAR 2000 WET&DRY LIBERTY Manual De Instrucciones página 38

ENGLISH
3. OPERATION
Installation
Fig. 4.
Loosen the clips.
Raise the hose assembly from the dust tank.
Take out all accessories from the dust container.
Install the casters. Align the corresponding holes, press down, and install the four caster on
the barrel.
Place the hose assembly on the dust container that already has a filter assembly and lock it
with both sides of the clips.
Open the battery cover. Do this by swinging up the cover. Then insert the battery and push it
down until you hear the battery engage.
Replace the battery cover.
Align the hose assembly port with the suction port, and then rotate it clockwise and insert it.
Optionally, three tube and hose assemblies can be installed.
Charging the battery
Fig. 5.
Take the battery pack out of the equipment.
Do this by pressing the side push lock buttons.
Check that your mains voltage is the same as that marked on the rating plate of the battery
charger. Insert the power plug of the charger into the socket outlet. Insert the battery charger
into the battery pack.
The charging light indicator will light up in red during charging.
The charging light indicator will light up in green when fully charged.
Note: The charge light indicator will turn green when the device is charged after a long period
of operation. After a few minutes, it will turn red and start charging. This is normal in order to
avoid overheating during charging.
Press the switch for the battery capacity indicator. The battery capacity indicator shows the
charge status of the battery using 4 LEDs.
All 4 LEDs are lit: The battery is fully charged.
3 or 2 LED(s) are lit: The battery has an adequate remaining charge.
1 LED is lit: No battery. Charge it.
Warning: Batteries must be charged normally within the room temperature range of 0 °C-45
°C. Charging should be prohibited when the room temperature is below 0 degree.
How to use the vacuum cleaner
Fig. 6.
38
CONGA ROCKSTAR 2000 WET&DRY LIBERTY