Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
PLUG THE TRANSFORMER INTO THE OUTLET
Plug the transformer into the 110 Vac outlet.
NOTE: Once power is applied, the EL1SS will constantly beep to indicate that it is powered, and is waiting to be programmed for the
unit's Master Code. The Master Code is used to unlock the programming functions of the EL1SS. The Master Code should not be
distributed as an Entry Code.
CLOSE THE UNIT
Use wire ties to organize the wires inside the
housing, leave enough length at the ends for
bends and service loops. Rotate the front panel up
while keeping the wires away from the panel to
prevent pinch damage. Lock the front panel.
SET THE UNIT MASTER CODE
The Master Code is needed when creating Entry Codes or
making any programming changes to the EL1SS.
Enter # # # on the unit's keypad.
Enter a 4 digit Master Code. Example: 1 2 3 4
If Master Code is accepted, the unit will respond with a dual
tone beep. If it is not accepted, the unit will respond with three
short low tone beeps.
Write down the Master Code and store in a secure location. See page
NOTE: The star (
) button acts as a cancel command that will end any call, programming or access code key sequence.
*
INSTALLATION
TEST
16.5 Vdc 2.5A,
Non-polarized
Power (included)
110 Vac Outlet
18.
12
SET UP
1
2
POWER
Check the Power LED
is illuminated.
Publicidad
