Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
ADDITIONAL SYSTEM PROGRAMMING USING THE KEYPAD
PROGRAM
DESCRIPTION OF FUNCTION OR SETTING
NUMBER
7
DELETE ENTRY CODE
9
CREATE A 4-DIGIT ENTRY CODE
NOTES:
• An Entry Code cannot be the same as the Master Code.
• A 4-digit entry code controls 1 relay immediately upon
entry.
CREATE A 5-DIGIT ENTRY CODE
NOTES:
• An Entry Code cannot be the same as the Master Code.
• A 5-digit entry code controls either door selectable at the
time of entry
51
CREATE TEMPORARY (1 TIME) ENTRY CODE
The EL1SS holds 1 temporary Entry Code.
NOTE: An Entry Code cannot be the same as the Master
Code.
52
ENABLE VACATION (LOCK DOWN) MODE
Factory Setting: Disabled
Locks the system from all Entry Code activity.
53
DISABLE VACATION (LOCK DOWN) MODE
54
ENGAGE PARTY MODE (RELAY 1)
Factory Setting: Disabled
Party Mode will latch relay 1.
56
ENGAGE PARTY MODE (RELAY 2)
Factory Setting: Disabled
Party Mode will latch relay 2.
NOTE: Output configuration must be in Independent Relay
Control (default) to engage Party Mode on relay 2.
INSTALLATION
Last digit = 1 opens door 1
Last digit = 2 opens door 2
TEST
PROGRAMMING STEPS
Master Code
(4 digits) +
7
(4 digits)
Master Code
(4 digits) +
9
that will be pre-assigned to this entry code). Wait to hear confirmation
from the system.
Master Code
(4 digits) +
9
Resident enters
Entry Code
device resident wishes to activate)
NOTE: If no button is pressed for Relay, both relays will activate
simultaneously, unless independent relay output control is enabled.
Master Code
(4 digits) +
51
digits) +
1
or
2
(Relay associated with the entry device resident wishes
to activate) or no button is pressed
NOTE: If no button is pressed for Relay, both relays will activate
simultaneously, unless independent relay output control is enabled.
Expires in 24 hours or after fi rst use.
Master Code
(4 digits) +
52
Master Code
(4 digits) +
53
Master Code
(4 digits) +
54
To disengage party mode: Enter a valid
keypad or enter "*9" into the local telephone.
Master Code
(4 digits) +
56
To disengage party mode: Enter a valid
keypad or enter "*5" into the local telephone.
15
SET UP
+
Entry Code
that is to be deleted
+
New Entry Code
(4 digits) +
+
New Entry Code
(4 digits)
+
1
or
2
(Relay associated with the entry
+ New Temporary (1 Time)
Entry Code
into the EL1SS
Entry Code
into the EL1SS
1
or
2
(Relay
Entry Code
(4
Publicidad
