Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
RESIDENT - SYSTEM PROGRAMMING USING THE HOUSE PHONE
A house phone is a telephone with an actual wiring connection to the EL1SS system. See call forwarding instructions on page 17.
PROGRAM
DESCRIPTION OF FUNCTION OR SETTING
NUMBER
**01
ENABLE CALL FORWARDING
Factory Setting: Disabled
NOTE: This setting requires the system to be connected to the residence's
phone line and Telco Mode to be enabled (see page 14).
**02
DISABLE CALL FORWARDING
**03
ENABLE INTERCOM MODE
Factory Setting: Disabled
**06
VERIFY CALL FORWARDING NUMBER (VIA CALLER ID)
Factory Setting: Disabled
**07
ENABLE TELCO MODE
Factory Setting: Enabled
**#8
ERASE CALL FORWARDING NUMBER
NOTE: This command will also disable the call forwarding mode.
**10
ADJUST "PICK UP" RING COUNT
Factory Setting: 5
**13
ENABLE ALTERNATE DTMF (DUAL TONE MULTI FREQUENCY)
PROGRAMMING
This feature changes the leading programming digits from ** to ## (and
*# to #*) to work around phone lines (or telephone equipment) that reacts
to the * tone.
Factory Setting: Disabled
NOTE: The telephone line should be disconnected while entering this
command.
**14
ENABLE STANDARD (LONG) RING TONE
Factory Setting: Enabled
**15
ENABLE ALTERNATE (DUAL) RING TONE
Factory Setting: Enabled
NOTE: Alternate ring tone function may not work with all phones
#*16
DISABLE ALTERNATE DTMF PROGRAMMING
*# Call
ENTER CALL FORWARDING TELEPHONE NUMBER
Forwarding
Number #
INSTALLATION
TEST
PROGRAMMING STEPS
**01
**02
**03
**06
Hang up the phone - Wait for the ring.
**07
**#8
**10
**13
**14
**15
#*16
*#
+
16
SET UP
+ Ring Count
2
through
5
Telephone Number
(Up to 14 digits) +
#
Publicidad
