Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the Fan
Blades
1. Insert the blade through the slot
cut-off in the center flywheel, align
the three screw holes in the blade
with the screw holes in the flywheel.
Secure with the screws provided.
(Figure 12)
2. Repeat this step for the remaining the
blades.
Motor Assembly
7.
Blade Balancing
All blades are grouped by weight. Because
materials vary in density, the fan may wobble
even though the blades are weight matched.
The following procedure should correct most
fan wobble. Check after each step.
1. Check that all blade screws are secure.
2. Most fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
from a point on the center of each blade
to the point on the ceiling. Measure this
distance as shown in Figure 13. Rotate
the fan until the next blade is positioned
for measurement. Repeat for each blade.
Measurements deviation should be within
1/8". Run the fan for 10 minutes.
Blade
3. Make sure that canopy is tightened securely
to ceiling mounting bracket and that the
ceiling mounting bracket is tightened
securely to the electrical box.
4. Interchanging two adjacent blades can
redistribute the weight and possibly result
in the smoother operation.
Screws
Figure 12
5. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
Touching
Ceiling
Figure 13
Publicidad
