HIKOKI CJ18DB Instrucciones De Manejo página 18

English
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
Symptom
Tool doesn't run
Tool suddenly stopped
Blade
- can't be attached
- fall off
Switch can't be pulled
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
Blade wears out too
quickly.
Unable to properly cut.
Possible cause
No remaining battery power
Battery isn't fully installed.
Tool was overburdened
Battery overheated
The shape of the attachment portion doesn't
match
The lever is open.
There is foreign matter inside the blade
holder.
Lock-off button is pushed in. (CJ18DA)
The trigger switch is being pulled only
slightly. (CJ18DA)
Proper machine oil not used when cutting
metallic materials
Number of strokes is too fast
Too much applied pressure during operation During operation, lighten the applied
Blade is inappropriate for the quality and
thickness of the material to be cut
Speed and orbital position are inappropriate
for the quality and thickness of the material
to be cut
Blade is worn, degraded or damaged
Charge the battery.
Push the battery in until you hear a click.
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Allow the tool and battery to thoroughly cool.
Use the appropriate blade
(See "Selecting accessories")
Close the lever.
Remove the foreign matter.
Release the Lock-off button.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Use machine oil (turbine oil, etc.)
Switch the dial to a lower setting than the
current one. (CJ18DB)
(Switch to low speed mode when cutting
stainless steel plates)
(See "Adjusting the blade operating speed")
pressure.
Use the proper blade
(See "Selecting accessories")
Set the appropriate speed and orbital
position
(See "Mounting and operation" Fig. 17–22
on page 15.)
Replace with a new blade.
18
Remedy