Descargar Imprimir esta página

Garland BEAR 804 VE-V20 Manual De Instrucciones página 40

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
English
5.2.2. HYDRAULIC LIFT
The hydraulics are factory folded and must be raised
before starting work. For its elevation:
Start the machine following the instructions in
point 5.3. START UP.
Remove the locking pin from the bolt and the
bolt to release the hydraulic cylinder (1)
Lower the cutter (Fig 4.2.-3) and pressure (Fig
4.2.-4) levers to raise the hydraulic cylinder to
the maximum (2).
Insert bolt (3) and safety pin to secure
hydraulic cylinder. (4)
2
1
3
4
40/156
Release both levers (Fig 4.2.-3) and (Fig 4.2.-
4), operate the reverse lever (Fig 4.2.-5) to
raise the blade. Remove the transport bracket
from the blade.
5.2.3. MOUNTING THE SHIELD ARC
Position the protection arch as shown in the figure,
securing it with the M10x30 screw with washer and
with the safety pin.
B
M10 × 30
× 1

Publicidad

loading