Uline H-9730 Instrucciones De Montaje página 2

NOTE: Assemble on smooth, non-marring
surface to avoid scratching.
NOTE: Use Allen wrench to tighten bolts.
NOTE: Use Phillips screwdriver to tighten screws.
NOTE: Check that all parts are included.
1. Attach adjustable glides (C) to bottom corners
of each side panel (2). (See Figure 1)
2. Align modesty panel (4) with holes in side panel (2).
Use three M6 x 45 mm bolts (B) to secure. Repeat
with second panel. (See Figure 1)
Figure 1
4
3. Place desktop panel (1) upside down with holes
facing up. With second person, turn assembled desk
frame upside down. Use 12 M6 x 45 mm bolts (B) to
secure desk frame to desktop. (See Figure 2)
Figure 2
PAGE 2 OF 24
ASSEMBLY CONTINUED
C
2
B
B
1
To continue desk assembly, proceed to step 4.
To continue L-desk assembly, proceed to L-desk
Return Assembly on page 4.
4. Insert four M6 x 14 mm shoulder screws (K) in desktop (1).
(See Figure 3)
NOTE: Shoulder screws (K) will not be flush
with desktop (1). Screws stick out slightly from
desktop for connection to pedestal file.
Figure 3
5. With second person, turn pedestal file (9) upside
down. Carefully lower pedestal file and align keyhole
tabs in pedestal file with shoulder screws (K) in
desktop panel (1). (See Figure 4)
NOTE: Pedestal file should rest on the desktop
panel and slightly hang over front edge.
Figure 4
K
9
1
K
0322 IH-9730