Peavey 00573700 Manual Del Usuario página 10

HIGH GAIN CONTROL (Channel 2) (10)
This controls output level of channel 2 highs signal (signal above the selected crossover point) present at
channel 2 high output XLR.
CROSSOVER SELECTOR CONTROL (Channel 2 lows/highs) (11)
This allows users to choose their desired crossover point for lows and highs for channel 2.The control range
is between 100 Hz and 1 kHz or 1 kHz and 10 kHz, depending on the position of the Range switch.
RANGE (x10) SWITCH (Channel 2 lows/highs) (12)
This switch multiplies the value indicated on the Crossover Selector Control times 10.When engaged, the
range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. Range x10 is indicated by the illumination
of the red LED above the switch.
R E A R P A N E L
1
4 3 2
IEC MAINS CONNECTOR (1)
This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings for
the intended operating voltage is included in the carton.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does
not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly.To prevent the risk of shock or fire hazard, always make sure that the equalizer and all associated
equipment is properly grounded.
Incorporated into this IEC MAINS CONNECTOR is the MAINS FUSE HOLDER. If for any reason you
are unable to power up this unit, remove the fuse by pulling out the holder. Check to see if the fuse is
operational. If not, then replace with a fuse of the appropriate value and rating. If the fuse continues to fail
contact your nearest Certified Peavey Service Center.
INPUT (Channel 1) (2)
This XLR female 3-pin connector provides a balanced input for channel 1.
LOW OUTPUT (Channel 1) (3)
This XLR male 3-pin connector provides a balanced output for the low frequencies for channel 1.
HIGH OUTPUT (Channel 1) (4)
This XLR male 3-pin connector provides a balanced output for the high frequencies for channel 1.