Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: On first ignition or after refueling, unit
may make a grinding sound just before
ignition. This is the fuel pump removing the air
from the fuel line. Heater will start up within
seconds. If it does not start, repeat start-up
procedures with fuel gauge reading at least
1/2 tank.
NOTE: Smoking may occur on first ignition.
NOTE: The electrical components of these
heaters are protected by a fuse mounted in
the PC board. If the heater fails to ignite, check
this fuse first and replace if necessary. Check
the power source to ensure the proper voltage
is being provided to the heater.
NOTE: If the heater does not ignite, move
switch to "Off" position, check steps 1-3 on
page 4 and then move switch to "On" position.
STOPPING THE HEATER (COOL DOWN)
Turn the power switch to the "Off" position. Combustion
will stop and the Cooling Cycle will begin and last
approximately five minutes. When the Cooling Cycle is
complete, the fan will stop running and it will be safe to
unplug the heater or disconnect the battery.
NOTE: Unplugging the heater or disconnecting
the battery before the Cooling Cycle has been
completed may cause overheating or possible
damage to the heater and heat plate.
RESTARTING THE HEATER
1.
Wait 10 seconds after Cooling Cycle has been
completed.
2. Follow all ignition procedures.
LONG-TERM STORAGE
Use an approved siphon to drain fuel through the fuel
cap opening.
IMPORTANT! Never store leftover kerosene or
diesel between seasons. Using old fuel can
damage heater. Do not disconnect heater
from power source before cooling cycle has
been completed.
PAGE 5 OF 31
OPERATION CONTINUED
BATTERY
Battery Voltage
Battery Pack Amp Hour
Estimated Run Time (Hour)*
* Note: Actual run time may vary due to battery condition and
ambient temperature.
NOTE: If the heater does not ignite, the
thermostat may be set too low. Turn the control
knob to a higher setting until the heater ignites.
If the heater does not ignite, move switch to
"Off" position, check steps 1-5 on page 4 and
then move switch to "On" position.
DANGER! Risk of fire. Never transport heater
with battery attached. Remove battery from
heater when not in use.
WARNING! Battery requirements: The batteries
(Lithium-ion battery packs) used with this
heater must be certified products that comply
with local safety regulations.
WARNING! Charger requirements: Use only the
charger specified by the battery manufacturer
for charging. Charging with another battery
pack may cause a fire hazard.
WARNING! Do not ignite or overheat the battery
or equipment. It may cause an explosion if
it catches fire or is higher than the battery's
required limit temperature.
WARNING! It is strictly prohibited to use
damaged or illegally modified batteries for
this machine as a power source, which may
cause fire, explosion, personal injury, property
damage and other hazards.
NOTE: This product will not charge the battery.
Remove the battery after using the product. If
not using for a long time, charge the battery
regularly to avoid affecting the battery life.
NOTE: If the existing battery cannot be installed
with the device, check local after-sales
solution.
BATTERY RUN TIME ESTIMATED
4
1.7
18/20 Volts
5
6
8
9
12
2.1
2.6
3.4
3.9
5.1
1223 IH-11009
Publicidad
