Uline H-11009 Manual De Instrucciones página 9

OPERATING ISSUE
Heater will not operate, or
motor runs for a short time.
Lamp flickers, and LED
E1
display shows " ".
Fan does not operate
when heater is plugged in,
and power switch is in the
"ON" position. The lamp is
flickering, or LED display
E1 E2
shows " " or " ".
Lamp is flickering, and LED
E3
display shows " ".
Poor combustion and/or
excess soot production.
Heater does not turn on,
and the lamp is not lit.
PAGE 9 OF 31
TROUBLESHOOTING CONTINUED
CAUSES
No kerosene in the fuel tank.
Incorrect pump pressure.
Corroded spark plug or incorrect plug
gap.
Dirty fuel filter.
Dirty nozzle.
Moisture in fuel tank.
Improper electrical connection between
transformer and circuit board.
Ignitor wire not connected to spark plug.
Defective ignitor.
Thermostat is set too low.
Broken electrical connection between
main PCB and motor.
Not enough amps available to power
heater.
Thermostat switch has failed.
Dirty fuel filter.
Poor quality of fuel.
PSI is too high or too low.
Dirty nozzle.
Temperature limit sensor has overheated.
No electrical power.
Fuse is blown.
Improper electrical connection between
temperature limit sensor and circuit
board.
1-800-295-5510
uline.com
RECOMMENDATIONS
Fill tank with fresh kerosene.
Adjust pump pressure.
Clean or replace spark plug.
Clean or replace fuel filter.
Clean or replace nozzle.
Rinse fuel tank with clean, fresh
kerosene.
Inspect all electrical connections.
Re-attach ignitor wire to spark plug.
Replace ignitor.
Rotate thermostat to a higher setting.
Inspect all electrical connections.
Use a new extension cord, or try
another electrical socket.
Replace thermostat switch.
Clean or replace fuel filter.
Flush fuel tank and refuel heater.
Use proper pressure.
Clean or replace nozzle.
Push power switch to "Off" and allow
heater to cool for 10 minutes. Restart
heater.
Check power cords for proper
connection, and test the power
supply. Ensure battery is fully charged.
Check or replace the fuse.
Inspect all electrical connections
1223 IH-11009