Makita RM350D Guía De Preparación página 22

Boundary wire installation conditions
You can set the boundary overreach of the Robotic Mower between 20 - 50 cm. This manual describes the conditions at the default setting (32 cm).
For details on the setting, refer to the chapter "Navigtion Preferences" in the instruction manual.
(b)
a) 5 cm or more b) About 35 cm
(b)
a) Less than 5 cm b) About 30 cm
a) Less than 1 cm b) About 10 cm
a) 15 cm or more b) 35 cm or more
Image
(a)
(a)
(b)
(b)
(a)
Separate by about 35 cm from obstacles with a height of 5 cm or more. (An area of
about 25 cm from the obstacle will be left unmowed. )
Use the supplied measuring gauge for making an appropriate distance from the
obstacles. (Trim out the measuring gauge along the perforation from the package.)
Separate by about 30 cm from obstacles with a height of less than 5 cm. (An area
of about 20 cm from the obstacle will be left unmowed. )
Separate by about 10 cm from obstacles with a height of less than 1 cm. (No area
will be left unmowed. )
(a)
If there are areas that the Robotic Mower should not enter or obstacles that the
Robotic Mower should not encounter, exclude the area by installing the boundary
wire around there. Refer to "Making an island" (page25) for details.
Place partitions (obstacles) with a height of 15 cm or more around the areas that
the Robotic Mower should never enter. In addition, install the boundary wire 35 cm
or more away from the partition in order to prevent contact with the partition. (An
area of about 25 cm will be left unmowed. )
22 ENGLISH
Condition