Makita RM350D Guía De Preparación página 23

a) 150 cm or more b) 150 cm or more
a) 35 m or less
2
1. Charging station 2. Guide wire 3. Boundary wire
a) 400 m or less b) 800 m or less
Image
(a)
(b)
(a)
1
(a) (b)
3
Do not bundle cables and wires. Doing so may intensify the signal and the Robotic
Mower will not operate properly.
- The width of the work area should be at least 150 cm or more. The Robotic
Mower returns to the charging station by following the boundary wire in
counterclockwise.
- Ensure that the boundary wire is at least 150 cm from the side of the charging
station.
Place the boundary wire so that the distance from the boundary wire to the
Robotic Mower is less than 35 m. If the distance from the nearest boundary wire to
the Robotic Mower is more than 35 m, the Robotic Mower will not work properly.
- The maximum length of the route starting from the charging station, guide wire,
boundary wire, and back in the charging station as illustrated in the figure should
be 400 m or less.
- The allowable space that you can limit by laying the boundary wire is up to 3,500
2
m .
- The maximum length of the boundary wire is up to 800 m including the islands
and sub areas.
23 ENGLISH
Condition