Trumpf TruTool F 140 Manual Del Usuario página 13

4 Consumables and
accessories
4.1 Tool selection
For good locking results, make sure that the
tools are clean and that they are changed
promptly.
For notes about wearing and consumable
parts, spare parts lists, see:
F 140
(2A1)
5 Troubleshooting
Problem
Seam is not tight.
Feed force increases, power
tool stops.
Sheet runs behind shaping
roller.
Power tool stops.
Power tool does not switch
on.
5.1 Replace the power cable
The power cable may only be re-
placed by the manufacturer or its contract
workshops to prevent safety hazards.
For TRUMPF service addresses, see:
www.trumpf.com
Cause
Material stability increased.
Border height lower.
Border wavy.
Driver rollers slip.
Power cable is defective.
Translation of the original operator's manual
Remedy
Increase pretension, see
u
Adjusting the pretension
[} 189].
B
Enlarge angle, see Adjust-
u
ing the angle [} 189].
A
Check dimensions for seam
u
preparation.
Increase pretension, see
u
Adjusting the pretension
[} 189].
B
Changing shaping roller
u
[} 191].
F
Make sure that the border is
u
maximum 90° to the duct
surface.
Adjusting the pretension
u
[} 189].
B
Replace the power ca-
u
ble [} 13].
EN
13