Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
NOTE:
•
If you change the music source, the TWS function will be disconnected.
•
If you want to make a TWS connection with a different speaker, remove previous
connections before attempting to connect the new speaker.
Operation
WARNING! Before plugging in and starting the speaker system, make sure that
all controls are turned off or set to a low level.
Playing music
1.
Plug the power cord into the back of the speaker and the wall socket.
button to turn on the speaker. HELLO will display on the screen and the
2.
Press the
speaker lights will briefly turn on. (Press the
speaker, BYE will display, and all lights will turn off.)
Connect to your audio source as described in the Connections section.
3.
4.
To select the playback source, press the
LINE. You can also press the
NOTE:
USB will only display when the USB is plugged in. When you connect a USB
•
memory stick the speaker will immediately enter this mode and start to play
the music.
•
Make sure the volume is turned up on both the speaker and external device
it is connected to.
5.
To control playback of the audio, you can either use your external device's controls (if
available), or you can use the following buttons on the speaker control panel:
Button
Mode
Master VOLUME
All modes
knob
BT/USB
BT/USB
BT/USB
button again at any time to turn off the
button continuously to select BT, USB, RADIO or
on the control panel to directly access the Bluetooth mode.
Action
Turn anticlockwise to lower the volume.
Turn clockwise to increase the volume.
Volume range is V00 to V40.
Press to play or pause the track or file.
Press to go to the previous track or file.
Press to go to the next track or file.
10
EN
Publicidad
