Descargar Imprimir esta página

Bosch B26FT Serie Instrucciones De Uso Y De Montaje página 20

Ocultar thumbs Ver también para B26FT Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us
Water filter
Do not use the appliance in places
where the water quality is unsafe or
unknown without taking suitable
disinfection precautions before and
after filtering.
A filter cartridge
for filtering
particles
can be obtained
from customer
service.
The water filter should be replaced
after 6 months at the latest.
After 6 months,
the flashing
water
filter symbol
prompts
you to replace
the filter cartridge
(see "Water
filter
symbol").
Other connection
requirements
Do not install the filter cartridge
if the
water
pressure
exceeds
116 psi
(8.0 bar).
If the water pressure
exceeds
80 psi
(5.5 bar), a pressure
reducing
valve
must be installed.
Important
note
Rinse the water system
thoroughly
if the appliance
has not been used
for a long period of time, or the
water
has an unpleasant
taste or
smell. To do this, extract water
from the water dispenser
for
several
minutes.
Replace
the filter
cartridge
if the unpleasant
taste or
smell persists.
The ice maker
and water
dispenser
can be used without
the
filter cartridge.
In this case, replace
the water filter with the bypass
cap.
Installing
and replacing
the
filter
cartridge
1. Pull out and then lower the cover.
Remove
the filter cartridge
carefully!
The water system
is under
low
pressure
after use.
2. Carefully
turn the filter cartridge
90 ° anti-clockwise
e.g. with a
spoon and pull it out.
3. Take the new filter cartridge
out of
its packaging
and remove
the
safety cap.
4. Insert the new filter cartridge
and
carefully
rotate 90 ° clockwise
as
far as it will go e.g. by using a
spoon.
8. Pour out the water
in the used filter
cartridge.
The filter cartridge
can
be disposed
of in the household
garbage.
9. Press and hold the "light/filter"
button
for 3 seconds.
The water
filter symbol
is reset. The symbol
stops flashing.
The new filter
cartridge
is activated.
The filter cartridge
must be
tightened
by hand so that no leaks
occur
and the the appliance
is
sufficiently
provided
with water.
5. Raise the cover
up and lock it in
place.
6. Turn on the water supply to the
appliance.
7. Draw about a gallon
of water from
the water dispenser.
This will
remove
air from the water system.
20

Publicidad

loading