Descargar Imprimir esta página

Bosch B26FT Serie Instrucciones De Uso Y De Montaje página 8

Ocultar thumbs Ver también para B26FT Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us
Aligning
the appliance
To ensure
that the appliance
operates
correctly,
use a level to
align the appliance.
If the appliance
is not level, water
may flow out of the ice maker,
ice
cubes
may be irregular,
or the doors
may not close properly.
Place the appliance
in the
designated
location.
2. Remove
the three screws
from the
base panel.
3. Remove
the base panel.
iiiii
_iI i_i
ii_
ii
i
4. Use a hexagonal
wrench
to loosen
the two front feet until they are
firmly planted
on the floor and then
align the front of the appliance.
5. Use a hexagonal
wrench
to turn
the screws
and then align the rear
of the appliance.
To raise the rear of the appliance:
Turn the screw clockwise.
To lower the rear of the appliance:
Turn the screw
counterclockwise.
6. Use the level to check
if the
appliance
is level.
To ensure
that the appliance
does
not move, the front feet must be
firmly planted
on the floor.
7. If the height of the refrigerator
compartment
doors
are uneven or
if the freezer
compartment
drawer
is slanted
after adjusting
the level
of the appliance,
use the following
method
to adjust them.
Adjusting a refrigerator door
If the height of the refrigerator
doors
is uneven:
1. Determine
which
refrigerator
door
needs to be raised.
2. Turn the screw nut on the lower
hinge to adjust the refrigerator
door.
To raise a refrigerator
door:
Turn the screw counterclockwise.
iiiiiiiiii
To lower a refrigerator
door:
Turn the screw clockwise.
8

Publicidad

loading