GreenWorks HTF320 Manual Del Operador página 9

EN
6.4 TURN THE REAR HANDLE
You can use the rotating button to adjust the rear handle to 5
different positions to cut the hedges easier.
1. Press the rotating button and turn the rear handle.
2. Release the rotating button until it locks into position.
6.5 OPERATION TIPS
• Do not push the machine through heavy shrubbery. This
can cause the blade blockage. If the blades blocks,
1. stop the machine.
2. Disconnect the plug from power source.
3. remove the blockage.
• Do not try to cut too large stems or twigs.
• Wear the gloves when you cut.
• Cut the new growth with a wide sweeping action so that
the stems are put directly into the blade.
• You can use a string to adjust the height of the hedge.
1. Stretch a piece of string along the hedge at this
height.
2. Cut the hedge immediately above this string.
3. Cut the side of a hedge until it will be narrower at the
top. More of the hedge will come into view in that
way.
7 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
English
Do not use strong solvents or detergents on the plastic
housing or components.
Pull the mains plug out of the socket before maintenance.
7.1 CLEAN THE MACHINE
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
7.2 LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to remove
more dirt.
• Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
8 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
9 TROUBLESHOOTING
Problem
The motor does
not start when you
pull the trigger.
8
CAUTION
WARNING
WARNING
NOTE
Possible cause Solution
Cord not plugged
Plug in cord.
in.
Cord or switch is Have cord or
damaged. switch replaced.