Pioneer F-223L Manual De Instrucciones página 4

ANTENNA CONNECTIONS
Radio reception is not possible unless the
antenna is properly connected.
The strength of broadcast signals varies from one area to
another (signal propagation is especially poor in metropolitan
areas, where there are many tall buildings, and in mountainous
areas). Proper antenna installation is vital to good reception.
AM ANTENNA
The AM loop antenna supplied with the tuner should be
connected to the AM antenna terminals. The antenna should
be placed at a distance from the tuner, and should not be
allowed to touch metallic objects. Avoid placing it near CD
players, personal computers, television sets, and other devices
generating radio frequencies.
Setting Up the AM Antenna
e Fold out the supports on the bottom of the antenna. Insert
the stopper in the hole in the antenna to lock them in place.
e Place the antenna on a level surface and rotate it to locate
the orientation that yields the best reception.
AM Loop Antenna Set-up Hole
AM Loop Antenna Stopper
Connection
The accessory AM loop antenna must be
connected to ensure proper reception.
External AM antenna
Indoor AM antenna
Provide a vinyl-coated wire (5 to 6 meters long). Secure one end
to the AM terminal and the other end to a wall or other high
location.
Outdoor AM antenna
If reception is still poor even when a lead antenna has been
stretched out indoors, stretch out a vinyl-coated wire and
secure it outdoors.
Connecting the external AM antenna
Outdoors AM antenna
indoor AM sofort |
NOTE: AM loop antenna
Do not detach the AM loop antenna when using the external
AM antenna.
4
<ARE1087>
FM ANTENNA
FM T-type Antenna Attachment
Connect the accessory FM T-type antenna to the FM terminals.
Stretch the antenna out to its full length, and affix it to a wall,
etc.
Correct Wrong Wrong
vy? be connected to ensure proper reception.
gielolele
(F-223)
External FM antenna installation
F-223L:
Use an external antenna when the signals from the station are
weak and cannot be picked up by the accessory FM T-type
antenna, or when the sound heard is accompanied by large
amounts of noise. There are two ways of connecting the
external FM antenna to the ANTENNA terminals: with 3000
feeder wire, or with a 750 coaxial cable.
It is recommended that you use the 752 coaxial cable, so that
the effects of extraneous noise are reduced to a minimum.
When the connecting cable
is a 750 coaxial cable
75 coaxial cable without
PAL connector
750, coaxial cable
= with PAL connector
When the connecting
cable is a 3000,
feeder wire
a
lo|@/e|o
F-223:
Use an external antenna when the signals from the station are
weak and cannot be picked up by the accessory FM T-type
antenna, or when the sound heard is accompanied by large
amounts of noise.
750, coaxial cable
fam with PAL connector