Pioneer F-223L Manual De Instrucciones página 5

NAMES AND USE OF PARTS
YQ PIONEER'
FM/AM DIGITAL SYNTHESIZER | TUNER F~223L
POWER
OFF = ON
@ POWER switch
When this switch is set to the on position, power is supplied
to the tuner's main circuits. The POWER switch is geared
to selecting the transformer's secondary so that even in the
off position, the unit's circuitry will work as long as the
power cord is connected to a power outlet. Disconnect the
power cord from the power outlet when you do not plan to
use the unit forea long period of time.
NOTE:
The memory will be backed up so long as the power cord
is not unplugged.
If the power cord is unplugged, the memory will be retained
for several days.
STATION CALL switches
These are used to recall preset broadcasting stations and
to preset the station.
MEMORY switch
This switch is used to memorize stations. When the switch
is pressed, the frequency indicator will flash. To memorize
the frequency of any station, press the STATION CALL
switch while the frequency display is flashing.
BAND selector switch
This is used to select the band of the desired station. The
bands change alternately each time the switch is pressed.
(F-223L)
P reception — MW reception — LW aa
(F-223)
ed
TUNING switches
These are used to locate the stations.
Push the "—" switch to go to a lower, and the "+" switch
to go to a higher frequency.
STEREO indicator
This lights when a stereo program has been picked up
during an FM broadcast.
TUNED indicator
This lights to indicate when the finest tuning of a station
has been achieved.
FREQUENCY display
Permits reading the received frequency at a glance from the
displayed figure. The FM band is indicated by MHz, and the
AM band by kHz.
FM MONO switch/indicator
Normally this is set to the off position (the FM MONO
indicator goes off). When noise spoils the reception of an
FM program, press the switch to the on position (the FM
MONO indicator will now light).
The program of an FM stereo broadcast will be heard in
mono. The setting of the FM MONO switch (on or off) is
memorized along with the station's frequency in the STA-
TION CALL switches.
When using the preset tuning feature, reception will be in
the mode selected when the station was memorized.
This switch will not function for AM reception.
AUTO/MANUAL TUNING switch/indicator
Use to select either the AUTO mode or MANUAL mode for
FM/AM reception. (When the auto tuning mode is selected,
the AUTO indicator will now light.)
5
<ARE1087 >