AEG NII84B10AB Manual De Instrucciones página 80

- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones even if
you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
6.7 Timer
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a single
cooking session.
Set the heat setting for the selected cooking
zone and then set the function.
1. Press . 00 appears on the timer
display.
2. Press or to set the time (00-99
minutes).
3. Press to start the timer or wait 3
seconds. The timer begins to count down.
To change the time: select the cooking zone
with and press
To deactivate the function: select the
cooking zone with
remaining time counts back to 00.
The timer finishes counting down, a signal
sounds and 00 blinks. The cooking zone
deactivates. Press any symbol to stop the
signal and blinking.
Minute Minder
You can use this function when the hob is
activated but the cooking zones do not
operate. The heat setting shows 00.
1. Press .
2. Press or to set the time.
The timer finishes counting down, a signal
sounds and 00 blinks. Press any symbol to
stop the signal and blinking.
80 ENGLISH
or .
and press . The
To deactivate the function: press
. The remaining time counts back to 00.
6.8 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones.
The hob controls heat settings to protect the
fuses of the house installation.
• If the hob reaches the limit of maximum
available power (refer to the rating plate),
the power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected first is always prioritised. The
remaining power will be divided between
the other cooking zones according to the
order of selection.
• For cooking zones that have a reduced
power, the control bar blinks and shows
the maximum possible heat settings.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
6.9 SenseBoil®
The function automatically adjusts the
temperature of water so that it does not boil
over once it reaches the boiling point.
If there is any residual heat (
on the cooking zone you want to use, an
acoustic signal sounds and the function
does not start.
The function does not work with non-stick
cookware.
CAUTION!
Do not use the function with empty
cookware.
Do not leave the hob unattended while
the function is operating.
1. Place pots filled with 1 - 5 l of cold water
on the available cooking zones for which
you want to start the function.
and
/ / )