Publicidad
Idiomas disponibles
Idiomas disponibles
Z2X12B30PSS, ZX12B36PSS, ZX12B48PSS Accessory Installation
OPTIONAL ACCESSORIES—12" HIGH BACKSPLASH
A WARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must
be protected by a backsplash constructed
of non-combustible material.
This stainless steel backsplash accessory
must be installed in combination with a custom,
non-combustible backsplash built beyond
the 12" height of the backsplash.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT: Save these instructions for local
inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING
CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner's Manual for future reference.
This kit provides for the installation of a 12"
high backsplash for 30", 36" or 48" Monogram
Professional Ranges and Rangetops.
TOOLS AND MATERIALS REQUIRED
¢Gloves to protect against sharp edges
¢T-15 and #2 Phillips screwdrivers
* Drill with 3/32" and 9/64" bits
¢Safety glasses
e Level
ePencil
This Kit Includes
¢Wall support panel
¢ Cover panel
¢ Hardware package with
- § Stainless Steel Torx 15 #8
self-tapping screws
- 5 Phillips #2 pan head wood
#10 screws
Wall Support
Panel
Cover Panel —
Hardware
Package
19
INSTALL 12" BACKSPLASH
A WARNING:
tris backsplash must
be securely fastened to the wall. Failure to do
so could result in damage or personal injury.
e Install and level the range or rangetop and
the range hood according to the installation
instructions.
e Remove the backsplash packaging and
protective film.
e Use level to pencil a horizontal line on the wall,
1/8" above the range or rangetop. The 1/8" gap
allows the cover panel to overlap the wall support
panel.
¢ Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
e Align the wall support panel on the marked
horizontal line and centered left to right.
e The wall support panel must be secured to the wall
at all 4 corners. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
e Place the cover panel over the wall support panel
and secure with Torx screws (provided). Install 2
screws on each side.
Install 4
Wood Screws
Wall Support
Panel
1/8"4
Joey
s e ,
Install T-15
a
_ a
Screws
Wall
7
-
Support
les
CG
Panel
|
eS
a
ee
Publicidad
