Monogram ZGP484NG Instrucciones De Instalación página 3

Design Information
CONTENTS Step 6, Roll Range into POSITION occ 14
. . Step 7, Level the RANGE .eeeecsccccccssssessssssssesssnnnnneeeseeeees 15
Design Information Step 8, Replace OVEN DOOTS......cssesesessssssssssssnneneeseseeeee 15
Models Available........ 3 Step 9, CHECK BUPNELS .secsscssecssseessseessnstestiessnsteseete 16
Backsplash ACCESSOTICS ......ssssessssssessssssssssnnesesecceennnsneees 3 Step 10, Check Operation of
Product Dimensions and Clearances wn. a? Oven Bake BUINELS...eeecccccccssssstteeseeccceeenneeee 16
Tools and Materials REQUIFE" .....eecccssseeeccssssetesssecsseees 8 Step 11, Adjusting the Bake Burner
. . at Shutter 16
Installation Preparation Step 12, Check Operation of
Power SUPPly LOCATIONS on. eeeeeesssssssscssssssseteesscccecennnneeee 9 Oven Broil Burner... 17
. . Finalize Installation 17
Installation Instructions Installation Checklist 17
Step 1, REMOVE! PACKAGING ..neeccssssssssteesssessssseesstenmneentesees 10 AccessorieS... 18
step 2, Move Range Indoors sersssssnennessscnnnennessennnnnsnssscees 11 ACCESSOTY INSTAIOTION oo oeeeeecccccssssssstesesseeeccceesnnmneneeeee 19-21
Step 3, Install Anth-Tip DeViCe senna le GOS CONVEFSION vrecsssssssssssssssssssnsssnsssnstnstseseeseeee 22-26
Step 4, Connect Range to GdS woes 13
Step 5, Connect ELOCtriCa..ee.cceccccccsseessccsssssteeesssssetnessseeee 13
MODELS AVAILABLE
These Monogram ranges are factory set for either
natural gas or LP gas. Order the model for your
installation situation.
48" Natural Gas Models:
ZGP484NG - 4 gas burners, grill and griddle
ZGP486NR - 6 gas burners and grill
ZGP486ND - 6 gas burners and griddle
48" LP Gas Models:
ZGP484LG - 4 gas burners, grill and griddle
ZGP486LR - 6 gas burners and grill
ZGP486LD - 6 gas burners and griddle
36" Natural Gas Models:
ZGP366N - 6 gas burners
ZGP364NR - 4 gas burners and grill
ZGP364ND - 4 gas burners and griddle
36" LP Gas Models:
ZGP366L - 6 gas burners
ZGP364LR - 4 gas burners and grill
ZGP364LD - 4 gas burners and griddle
30" Natural Gas Model: ZGP304N
30" LP Gas Model: ZGP304L
BACKSPLASH ACCESSORIES
All models require 12" minimum clearance to a
vertical combustible surface at the rear. If clearance
is less than 12", the entire surface of the back wall
above and the full width of the range must be
protected by a backsplash. The backsplash must be
constructed of non-combustible material, such as
metal, ceramic tile, brick, marble or other stone.
Two Backsplash Accessories Available:
¢ The 12" high stainless steel backsplash accessory
is available. Use this backsplash in combination
with a custom, non-combustible backsplash built
beyond the 12" height. The combined height of
the backsplash accessory and the custom
backsplash must reach the bottom of a hood,
or when there is no hood, to 48" above the
cooking surface.
e An adjustable 30" to 36" high backsplash with
shelf is also available. This backsplash fills in the
space between the top of the range and the
bottom of the hood. The shelf is positioned so that
heat lamps from the bottom of a Monogram
professional hood are directed towards the shelf.
12" High Backsplash
ZX12B48PSS, for 48" wide ranges
ZX12B36PSS, for 36" wide ranges
ZX12B30PSS, for 30" wide ranges
30" to 36" Adjustable Height
Backsplash With Shelf
ZXADJB48PSS, for 48" wide ranges
ZXADJB36PSS, for 36" wide ranges
ZXADJB3OPSS, for 30" wide ranges