Monogram ZGP484NG Instrucciones De Instalación página 25

Installation Instructions for Gas Conversion
[|6BICHANGE COMPANION BAKE BURNER
ORIFICE (if present)
Locate the 3/4" long bake burner orifice.
Select the proper orifice size for your gas and burner
from the conversion chart.
A.
B.
. Lift the front of the
. Use a 1/2" deepwell
socket to remove and
replace the orifice.
Remove the oven door and set aside in a safe
iocation.
Remove the 2 oven bottom hold-down screws
from the rear of the cover.
Slide the oven bottom forward and set asside.
Remove the burner diffuser screw.
CHS ggg eg
h Le
Diffuser Screw
Lift the front of the burner diffuser up slightly and
Slide it forward to disengage the clips at the rear.
Set the burner diffuser aside.
Remove the 3 burner
retension screws (lin —o
front and 2 at the rear)
burner up slightly and aN \ ao rner
i _ SN etéension
Slide leftward to re \. eal
move, \
Push excess capillary
back into the entry
hole.Place the unused f
orifice in the holder for ~>j===**—->
possible future use.
25
CHANGE MAIN/COMPANION BROIL
BURNER ORIFICE
Locate the broil burner orifice.
Select the proper orifice size for your gas and
burner fram the conversion chart.
The rear cover should still be removed from
converting the regulator(s). Refer to section 2 for
details if itis not.
A. Remove the 2 broil duct cover retension screw.
Lift up and slide out to remove.
aK Remove
Fee Ne |
; 2)
screws
B. Loosen and remove the broil supply tube nut
from the broil orifice holder.
C. Using an adjustable wrench and a 7/16" (11 mm)
box end wrench to loosen and remove and re-
place the broil orifice.
D. Reverse these steps to reassemble the griddle.
Push excess capillary back into the entry hole.
Place the unused orifice in the holder for pos-
sible future use.