StarLab ErgoOne E Instrucciones De Manejo página 19

NOTICE!
The GEL mode requires very slow dispensing speeds in order to prevent sample turbulence. In
order to ensure optimum dispensing, the dispensing speed is set at the factory. It is considerably
slower than the adjustable level 1 and cannot be selected individually.
5.5 DISP mode
Program for dispensing an aspirated liquid in partial steps. Slightly more fluid is aspirated than is
mathematically necessary.
Volume and speed setting, see Set volume and Set the aspiration and dispensing speed.
g. Dispense liquid in GEL mode: To dispense, briefly
press the pipetting key once. A rhombus appears
in the display. The aspirated volume is slowly
released again.
1x
h. The dispensing of the sample can be interrupted by
pressing the pipetting key again.
The display shows the volume of the liquid

dispensed.
i.
Trigger blow-out: After the last pipetting, press
1x
'Enter' key.
The display now once again shows 'blo' for blow-

out.
j.
End pipetting: By pressing the pipetting key once,
the blow-out is triggered, and the residual liquid is
dispensed.
After dispensing the residual liquid (blow-out), the

display jumps back to the set mode (start position).
1x
3x
a.
Call up menu selection: Pressing the menu key
three times takes you to the program selection.
'Mode' flashes.

b.
Set DISP mode: Use one of the arrow keys to scroll
through the modes until 'DISP' appears.
'Mode' continues to flash.

ErgoOne E Multi-Channel Pipettes · User Manual · 19
®