Hansgrohe Croma Showerpipe 27143 1 Serie Instrucciones De Montaje página 2

Tools Required / Outiles Utiles /
Herramientas Útiles
2
17 mm
⅞"
30 mm
¼" / 6 mm
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
Flow rate - tub filler
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The installation dimensions shown in this installation
instruction are ideal for people of approximately
6' in height. The dimensions can be changed if
required. In this case, the minimum ceiling height
of 86⅜" from the standing surface, and all other
measurements, must be changed.
• The installer must ensure that the entire area of the
wall to which the mounting plate is to be mounted,
is flat (no protruding grout joints or tiles). He should
also make sure that the wall is strong enough to sup-
port the showerpipe.
• The enclosed screws and anchors are suitable for
a solid surface wall. If installing in a fiberglass or
acrylic shower unit, install header boards at the
mounting points.
• This showerpipe requires showerpipe rough
16181181(not included).
• To prevent scald injury, the maximum output
temperature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum output
temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.0 GPM max.
1.75 GPM max.
5.3 GPM@ 44 PSI