Vermeiren Plego Manual De Instrucciones página 21

6
Troubleshooting
WARNING
 NEVER attempt to repair the operating console yourself.
 For failures of the operating console, you need to contact your specialist dealer. He/She
decides if the console needs to be reprogrammed.
In case of a possible problem, a system code is displayed by the blinking LEDs of the battery
status indicator, see §3.3 (2). The following table summarises the possible system codes. Some
problems can be solved by yourself. For all problems marked in grey, consult your specialist
dealer.
Table 2: Troubleshooting
Code Problem
Empty battery / bad
1
connection to battery
Bad connection of left motor
2
or encoder
Faulty wiring on left hand
3
motor / stall condition
Bad connection of right
4
motor or encoder
Faulty wiring on right hand
5
motor / stall condition
Joystick fault
7
Communication fault
7 + S 1
Possible controller fault
8
Parking brake bad
9
connection
Excessive voltage
10
1 S = Flashing Speed Indicator LEDs.
Risk of injuries and damage to the operating console or wheelchair
Meaning
Check the connections to the batteries. If the connections are good, try
charging the batteries.
Check the connections to the left hand motor and encoder.
Check the connections to the right hand motor and encoder.
Make sure that the joystick is in the centre position before switching on
the controller.
Make sure that the joystick module cable is securely connected and not
damaged.
Make sure that all connections are secure.
Check the parking brake and motor connections. Make sure the
controller connections are secure.
Excessive voltage is usually caused by a poor battery connection. Check
the battery connections.
19
EN
Plego
2023-09
Troubleshooting
NL