Jata JVTE4240 Instrucciones De Uso página 13

6. Two motor support anchors (5) with different lengths are included. Choose the one that best suits your
ceiling height.
7. Unscrew the upper screw of the engine mount anchor, slide the plastic plunger down and remove the pin.
Fig. 4
8. Remove the retaining clip to extract the pin from the lower end of the engine support anchor (5)
9. Insert the roof trim (4) and the engine trim (6).
10. Next, pass the upper engine cables through the inside of the engine support anchor (5) to the other end.
Fig. 5
11. Insert the upper pin of the engine support anchor (5), moving the connection cables aside, and raise the
plunger to the end. Then tighten the screw to secure it securely. Fig. 7
12. Subsequently, insert the motor support anchor (5) into the upper motor anchor (7) and secure it by
inserting the pin with the retaining clip and tightening the screw. Fig. 6
13. Place the ceiling support frame (2) in the desired location, ensuring that the ceiling power cables are
centered to make the subsequent connection.
14. Make the holes in the ceiling, taking into account the previous indications about the types of surfaces, and
anchor the ceiling support frame (2). Fig. 8
15. Make sure that the electrical current is disconnected.
16. Place the semi-assembled fan by inserting the piston of the motor support anchor (5) into the ceiling
support frame (2) matching the groove of the piston with a small notch in the support frame. Fig. 9
17. Place the Receiver (3) on the ceiling support frame (2). Note that the wires from the receiver must be on
the side of the receiver where the power strip is located.
18. Then, make the connections according to the following diagram: Fig. 10
19. Unscrew the screws of the roof trim (4).
20. Once connected, place the roof trim making it coincide with the holes of the support frame (2) by turning
and insert the screws.
21. Once located on the ceiling, place the ceiling lamp (10) making it rotate on the LED support (8). You can
now connect the electrical current. Fig. 11 and 12
INSTRUCTIONS OF USE
• To link the fan with the remote control, press the on/off button (a) on the remote control for 2 seconds until
you hear a sound, thus completing the link successfully.
• Remote control (13) :
-Off button (a).
-Speed control (1-2-3-4-5-6) (b).
-Light button (c).
-Off timer (1H-2-4H-8H) (d).
-Natural air mode (e).
-Winter mode(f).
• Turn on the fan by pressing any of the speed control numbers (b) and press the off button (a) to turn it off.
• Press the speed control (b) to choose the desired speed from 1 to 6.
• To switch on the light, push the lighting button (c):
-1 pulsation: Cold light.
-2 pulsations: OFF.
-3 pulsations: Intermediate light.
-4 pulsations: OFF.
-5 pulsations: Warm light.
-6 Pulsations: OFF.
13