Publicidad
7
Install interior assembly.
7a Connect all cables. Match cable color to label.
7b Hold assembly against plate and secure with two (2) screws.
Do not pinch cables. Tuck wires towards the bottom to avoid
interference with the battery holder
BAG 4
Actual size
7c Install batteries and tray.
The lock will begin to initialize when the battery holder
L
is installed. See Testing (pg 6).
NOTICE
8
Install lever.
8a Loosen set screw in lever, using included hex wrench.
8b Push lever into place.
8c Tighten set screw firmly.
~15 in-lb
(2 Nm)
Complete Testing (pg 6) now, before installing
L
covers.
9
Install cover.
9a Slide cover onto assembly. Secure with two (2) screws.
BAG 5
Actual size
5
NOTICE
Hand tighten only.
Repeated lever
removal may lead
to failure of the set
screw.
Publicidad
