Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance / Battery
EN
9. Connect and tighten the oil pipe, then reinstall the wire clamp.
10. Take the truck off of the 200 mm (8 in) block, then remove the battery.
11. Open the screw on the tank, then fill the tank with L-HV32 hydraulic oil, close
the screw on the tank, then install and connect the battery.
CAUTION
To avoid damage to the seal ring and oil leaks, always bleed the air from the
cylinder after replacement.
12. Loosen screw (item 11), then use a truck to lift a pallet with a load of at least
500 kg (1102 lb). Lift and lower the pallet 2 or 3 times to bleed air from the
cylinder, then tighten the screw.
13. Reconnect the battery.
EN82 - Use and maintenance manual
Publicidad
