Create Dryzone XL-Cubic Manual De Instrucciones página 9

HUMID IT Y LE VE L AND T IME R DI SPL AY
The indicator features 3 functions:
1. When the unit is plugged in, the power light will be on. When the unit is switched on, it
will indicate the room humidity level.
2. When you set the humidity, it will indicate the humidity that you have selected.
3. When you programme the time for the unit to turn on and off, it will show the time.
• When the environment humidity is lower than 35 %, it will show 35.
• When the environment humidity is higher than 95 %, it will show 95.
• The Power indication light will turn on when the unit is plugged in, regardless of whether
the unit is operating or not.
• Press Power button once to start working. Press it again to stop it.
• Press Fan button as follows to set the desired fan speed. It can be adjusted between high
speed and low speed.
• Press Settings button and Up / down button to set the desired humidity level in the room,
which can be set from 40 % to 80 % at 5 % intervals.
• After a period of working, when the environment humidity is lower than the selected hu-
midity by 2 %, the compressor will stop. When the environment humidity is equal to or
higher than the selected humidity by 2 %, the compressor will restart once the 3-minute
compressor protection time is over.
• Press Timer button and Up / down button to programme the time to turn the unit on or off.
Press Timer and Up / down button to set the time from 1 to 24 hours. If you press the timer
button again, the timer will be cancelled. The programmed time remains unchanged even
if the machine stops working due to water tank full condition or during defrosting.
• Press the Lock button to activate Child lock. You can activate it by pressing the button for
more than 5 seconds. The lamp will light up and all the buttons will be locked too. Press
the button again for more than 5 seconds, until the lamp turns off, to cancel Child lock.
When the drainage tank is full, the water full tank indicator light will blink and the com-
pressor will stop working and will become fan only. The buzzer will beep to alert the user
that the water needs to be emptied from the drainage tank.
E MPT YI N G THE D R AINAGE TANK
1. Lightly press on the sides of the tank with both hands and pull the tank out gently.
2. Discard the collected water.
NOTE:
• Do not remove the float from the water tank. The water full sensor will no longer be able
to detect the water level correctly without the float and water may leak from the water
tank.
• If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use detergent,
scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or other sol-
vents, as these can scratch and damage the tank and cause water leakage.
OPERATING INSTRUCTIONS
DRAINING THE COLLECTED WATER
E NGLI SH
9