Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC RECORDING
4 Press the @ button to start recording.
6 —.
—.
?
Preparation
Set the tape to the point where recording
will start.
Only Type I (normal) tapes can be recorded.
1
2
3
Insert the tape to be recorded on into the deck.
Insert the tape with the side to be recorded on first facing
out from the unit
and the exposed
side down.
Press theTAPE button to select the reverse mode.
To record on one side only, select 1.
To record on both sides, select =) or (1).
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD,
press the CD button and load the disc.
To
record from a radio broadcast,
press the TUNER button
and tune in to a station.
To
record from the connected source,
press the AUX button
and prepare to play.
m
When the selected
function
is CD, playback
and recording
start simultaneously.
When the selected
function
is AUX, start playback
on the
connected
equipment.
To stop recording,
press the 9 button.
To pause recording,
press the 11 button. (Applicable
when the
source is TUNER
or AUX.)
To resume
recording,
press again.
To start recording with the remote control
First press the ~ button, and then press the >
button within 2
seconds.
m
Recording
cannot be done when the TAPE function
is selected.
INSERTING BLANK SPACES
Insertion
of 4-second
blank s~aces
may help you to locate the
begining
of the track on other equipmeht.
(Applicable
when the
source is TUNER
or AUX.)
1 Press the O button
during
recording
or while in recording
pause
mode.
~flashes
for 4 seconds
and the tape
runs
without
recording,
After 4 seconds,
the deck enters
the recording
pause mode.
2
Press the II button to resume recording.
[m
To insert
a
blank space of less than 4 seconds,
press the @
button again while w
is flashing.
To insert blank spaces of more than 4 seconds,
after the
deck enters recording
pause mode, press the
button again.
Each time the button
is pressed,
a 4-second
blank space
is
added
To erase a recording
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure
is to be started.
3 Set the reverse mode by pressing
the TAPE button.
4
Press the AUX button.
If an optional
equipment
is connected
to the AUX jacks, turn
it off.
5
Press the
button to start the erasure.
ENGLISH
12
Publicidad
