Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE OPERATION
SETTING THE CLOCK
To turn the unit on
Press one of the function
buttons
(TAPE, TUNER,
AUX, CD).
Playback
of the inserted
disc or tape begins,
or the previously
tuned station is received
(Direct Play Function).
The POWER
button is also available.
After use
Press the POWER
button
to turn off the power.
The display
changes
to the clock,
Ueing the headphones
Cc,nnect the headphones
to the PHONES jack with a stereo mini
plug (rz3.5 mm, '/8 inch).
Nc, sound is output from the speakers
while the headphones
are
plugged
in.
1,3,5
2,4
E-=-=2+5=-=4
CLOCK
SHI[:T
When the AC cord or the car battery cord is connected
for the
first time, the time on the display flashes.
Set the time as follows while
the power is off.
1
2
3
4
5
Press the 11 button.
The hour flashes.
Press the +-4
or
F button to designate
hour.
Press the II button to set the hour.
the
The hour stops flashing
and the minute starts flashing.
Press the +-4
or W
button to designate the
minute.
Press
the
II button
to set the minute
and
complete setting.
The minute stops flashing
on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn the unit off. Press the 1I button,
the clock display flashes and carry out steps 1 to 5 above,
To display the current time
Press the CLOCK
button while pressing
the SHIFT
button
on
the remote control.
The time is displayed
for 4 seconds.
However,
the time cannot be displayed
during recorcling.
To switch to the 24-hour standard
Press the CLOCK
button while pressing
the SHIFT
button
on
the remote control and then press the
button within 4 seccmds.
Repeat the same procedure
to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused
by a power interruption.
The current time needs
to be reset.
If power is interrupted
for more than approximately
12 hours, all
settings
stored in memory
after purchase
need to be reset.
5
ENGLISH
Publicidad
