Aiwa LCX-350 Manual De Instrucciones página 8

MANUAL TUNING
1
2
BANDI
MODE
TUNER
SHIFT
Press the TUNER button repeatedly to select the
desired band.
m
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
\AJhen using the remote control, press the BAND/MODE
"WNER button repeatedly while power is on.
Press the q< or > button to select a station.
Each time the button is pressed the frequency changes.
\Nhen a station is received,
"TUNE'r
is displayed for
2 seconds.
During FM stereo reception, "STEREO" is displayed.
When an FM stereo broadcast contains
Inoise
Press the BAND/MODE TUNER button while pressing the SHIFT
button on the remote control.
"MONO" appears on the display.
Noise is reduced, although reception is monaural.
m
To restore stereo reception, press the buttons again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER button
during power on.
TO reset the interval, repeat this procedure,
Bm
When the AM tuning interval is changed, all preset stations
(see "PRESETTING STATIONS") are cleared. The preset
!stations have to be set again.
To search for a station quickly (Auto Search)
Keep the +< or F button pressed until the tuner starts
searching for a station, After tuning in to a station, the search
Stolps,
To stop the Auto Search manually, press the <<or ›~ button.
* The Auto Search may not stop at stations with very weak
signals.
7
ENGLISh!