RECARO Ergomed E Instalación Eléctrica página 15

Safety instructions
General
Fit the electrical connection for the RECARO seat as per
these instructions.
RECARO accepts no liability for the seat if the seat,
adaptation or vehicle floor assembly is modified.
Any modification to our product will not only exclude any
liability but will also void the warranty. This also applies if
non-permitted components are used.
DANGER
Risk of electric shock!
An improperly fitted electrical connection can cause
„
short-circuits.
If this happens, it could ignite a fire inside your
„
vehicle and pose a significant risk to your safety,
health and even your life in the worst case.
If you do not have the required knowledge and
tools, you must have the seat and electrical
connections fitted by a specialist workshop.
It takes care, patience and precision to install
a seat. Before commencing installation, ensure
that you have parked the vehicle safely and
that you maintain a sure footing at all times
when carrying out the work.
Validity of these installation instructions
These installation instructions are valid for the types of
RECARO seats listed on the cover page.
Installation parts
Take the required installation parts from the accompany-
ing polythene bag.
The connection to the vehicle electrical system depends
on the vehicle type. The accompanying connection parts
will fit the majority of vehicle types.
Preparation
WARNING
Unintentional triggering of airbags and belt
tensioners!
Serious injuries caused by flying parts.
Remove the ignition key and do not re-insert it until
„
refitting has been completed.
Disconnect the battery negative terminal and leave
„
the battery disconnected until refitting has been
completed.
Before starting work, wait for 20 minutes so that the
„
capacitors in the belt tensioners' and airbags' con-
trol units have time to discharge.
A Electrical seat connections
A1 Electrical connection for the RECARO seat
with installed switch (Figures A and B)
Included with the seat are:
• One cable harness with connectors (2)
• Ring tongue (3) (ground connection)
• One connectivity terminal (power connection)
• One fuse holder (4) with two spring contacts (5) and a
20 A fuse
1.1 Installation (Figure A)
1. Connect the enclosed cable harness (2) with the
two-pin connector (1) on the seat.
2. Take the seat adjustment path into consideration
when laying the cable.
Ground connection (-)
3. Fit the ring tongue (3) onto the end of the brown
cable (-).
4. Connect the brown cable to an grounding point on
the vehicle body.
1.2 Power connection (+) (Figure D)
Key to Figure D
V1 Version 1: Fuse slot available
V2 Version 2: No fuse slot available; connect directly to
cable
(4) Supplied fuse holder
(8) Fuse box
(9) Signal connection terminal 15 (variant 1)
(10) Load connection battery (+)
(11) Battery
(12) Relay
The red cable (+) must be connected to a terminal with
switched power supply (e.g. Terminal 15).
Select according to vehicle type:
Variant 1 – Connection type A
Fuse slot available
1. Select an unoccupied fuse holder with switched
power supply in the fuse box (e.g. Terminal 15).
2. Attach the red cable (+) with the connectivity
terminal to the fuse holder connection terminal.
3. Insert a 20 A fuse.
15