Celexon CLR HomeCinema UST Manual De Usuario página 16

INSTALLATION NOTES
Install the screen in a position that is fully visible to all viewers! The optimum
installation height corresponds to the position of the viewers in the centre of
the screen with the screen fabric extended: eye level = lower third of the screen
surface. Install the screen in a straight and level position, otherwise there is
a risk that the screen fabric being wound up and unwound crookedly. The
screen may only be installed in such a way that the fabric extends upwards!
Use suitable dowels and screws for the mounting surface (if necessary, obtain
suitable mounting material). With this screen, you have the option of choosing
between different mounting variants.
MOUNTING ON THE FLOOR
CAUTION! Make sure the surface is load-bearing and level. Carefully unpack
the screen and remove any packing material. Make sure that the screen is lifted
by at least two people.
Position the screen where you want it and slide the feet underneath the housing
into position and align the screen. Make sure that there is enough space for the
screen to extend to its full height and that no objects obstruct the extension
area.
WALL MOUNTING
(MOUNTING BRACKETS OPTIONALLY AVAILABLE)
CAUTION! Make sure the surface is load-bearing and level. Carefully unpack
the screen and remove any packing material. There are rubber pads on the
underside of the housing, the brackets must be fitted so that the screen goes
on the rubber pads so that it does not slip. Then measure the distance between
the brackets and transfer this to the installation surface.
Use the brackets as a template and draw the mounting holes on the wall.
5