Celexon CLR HomeCinema UST Manual De Usuario página 17

Then pre-drill the holes and insert suitable dowels (suitable material may have
to be procured separately). Fasten the mounting brackets to the wall with
suitable screws. Now lift the screen housing with two people and place it
carefully on the brackets.
Make sure that the screen is standing on the brackets with the rubber pads on
the bracket and slowly lower the case downwards and only let go when the
case is actually held firmly by the brackets.
OPERATION
CONTROL VIA THE HOUSING BUTTONS
Connect the enclosed power cable to the screen and to power. Make sure that
the power supply is correct. Do not lay the cable on hot surfaces and avoid
tension. Switch the power button to ON. A control signal sounds.
Power supply control
0 = Off I = On
I = Up 0 = Stop II = Down
6