Hitachi DA-300E Manual Del Propietário página 15

Ⅲ . WARNINGS AND SAFETY INSTRUCTIONS
Be sure that anyone operating this machine has read and fully understands this manual and it's
��
content. Failure to follow all safety instructions can result in serious injury or death.
Be Operator safety
•
Always wear a safety face shield or goggles.
•
Always wear heavy, long pants, boots and gloves. Do not wear loose clothing, jewelry, short pants,
sandals or go barefoot. Secure hair so it is above shoulder length.
•
Do not operate this unit / machine when you are tired, ill or under the influence of alcohol, drugs or
medication.
•
Never let a child or inexperienced person operate the machine.
•
Wear hearing protection.
•
Never start or run the engine inside a closed room or building. Breathing exhaust fumes can kill.
•
Keep handles free of oil and fuel.
•
Keep hands away from drilling equipment.
•
Do not grab or hold the unit by the drilling equipment.
•
When the unit is turned off, make sure the drilling attachment has stopped before the unit is set
down.
•
When operation is prolonged, take a break from time to time so that you may avoid possible
whitefinger disease which is caused by vibration.
•
Be sure to check all fasteners on the machine to ensure that nothing can come loose during
operation.
•
Be sure that the area you intend to dig is free of any obstacles and obstructions. Some items may be
buried beneath the surface, such as electric wiring, water lines, etc. If you have doubts about their
location-consult your local utility experts.
•
This auger is designed to bore through earth. Never attempt to bore through any solid objects such
as wood, rock or metal.
•
Never alter or replace the pin securing the auger bit to the power head. Using anything other than
the original pin can result in injury.
•
This model is designed to accept an auger bit with a maximum diameter of 12 inches. Never attempt
to use a larger bit with this machine.
•
Prior to starting be sure that both operators are in a position to firmly grasp both handles and are
able to gain secure footing. Never operate on steep inclines where the potential to fall is increased.
•
Holes created by this machine can be dangerous to others. Never leave a hole unattended where it
may create a safety hazard.
Unit / machine safety
• I nspect the entire unit/machine before each use. Replace damaged parts. Check for fuel leaks and
make sure all fasteners are in place and securely tightened.
• Replace parts that are cracked, chipped or damaged in any way before using the unit/machine.
• Keep others away when making carburetor adjustments.
• Use only accessories as recommended for this unit/machine by the manufacturer.
WARNING!
Never modify the unit/machine in any way. Do not use your drilling tool for any job except that
for which it is intended.
Fuel safety
•
Mix and pour fuel outdoors and where there are no sparks or flames.
•
Use a container approved for fuel.
•
Do not smoke or allow smoking near fuel or the unit/machine or while using the unit/machine.
•
Wipe up all fuel spills before starting engine.
•
Move at least 3 m away from fueling site before starting engine.
•
Stop engine before removing fuel cap.
•
Empty the fuel tank before storing the unit/machine. It is recommended that the fuel be emptied after
each use. If fuel is left in the tank, store so fuel will not leak.
•
Store unit/machine and fuel in area where fuel vapors cannot reach sparks or open flames from
water heaters, electric motors or switches, furnaces. etc.
10