Publicidad
Idiomas disponibles
Idiomas disponibles
•
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
•
A markets national or local regulations can set limit
to the transportation of the product.
•
The operator of the transport vehicle is responsible
to attach the product safely during transport. Refer to
Transportation on page 34 .
Safety instructions for maintenance
WARNING:
can cause injury or damage to property or
the adjacent area. Do not do maintenance
on the engine or the cutting deck without
these conditions:
•
The engine is off.
•
The product is parked on a level surface.
•
The parking brake is applied.
•
The ignition key is removed.
•
The cutting deck is disengaged.
•
The ignition cables are removed from the
plugs.
WARNING:
the engine contain carbon monoxide, an
odorless, poisonous and very dangerous
gas. Do not run the product in closed spaces
or spaces with not sufficient air flow.
WARNING:
instructions that follow before you do
maintenance on the product.
Introduction
WARNING:
safety chapter before you assemble the
product.
To remove the product from the carton
1. Remove loose parts included with the product.
2. Remove the end panels.
3. Remove the side panels and put them on a flat
surface.
4. Remove all package materials.
5. Remove the product from the carton and make sure
no loose parts are left in the carton.
Assembly tools
•
1/2" (13 mm) wrench
10
The product is heavy and
The exhaust fumes from
Read the warning
Assembly
Read and understand the
•
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
18 .
•
Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
•
Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
•
Let the product become cool before you do
maintenance near the engine.
•
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
•
Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION:
instructions that follow before you use the
product.
•
Do not turn over the engine if the spark plug or
ignition cable is removed.
•
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
•
Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged.
•
The product is approved only with the equipment
supplied or recommended by the manufacturer.
•
7/16" (11 mm) wrenches (2 pieces)
•
Tire pressure gauge
•
Knife
•
Pliers
•
Socket wrench set (optional)
Loose parts that need assembly
The product is not fully assembled. The parts that follow
are loose when the product is purchased.
Key, 2 pcs
Slope sheet, 1 pcs
Read the caution
2235 - 002 - 22.09.2023
Publicidad
